Warping Torsion
If the Perform warping analysis check box in the Details dialog box has been selected (see Chapter 3.1.5), the results of the ultimate limit state designs considering seven degrees of freedom appear in this window. The table below shows the intermediate values of the warping torsion analysis.
The details contain information about the Design Internal Forces of the equivalent loads on the deformed system (see Knowledge Base article on our website). Among other things, the Critical Factor αcrit, the Longitudinal stress due to bimoment BEd, and the Secondary Torsional Shear Stress τt,sec,Ed are output as well.
You can use the button to graphically check the mode shapes of the set of members (see Chapter 5.4).