57 Results
View Results:
Sort by:
Question
How is coupling between individual layers controlled in the RF‑LAMINATE add-on module?
Question
Why it is not possible to design a biaxial bending with the RF‑/JOINTS add-on module?
Question
For the foundation design, I need the results (support reactions) of the design situation for "static equilibrium". How do I get them?
Question
How do I superimpose generated equivalent loads from the seismic analysis?
Question
For design, I need the load combinations from 1.00*G + 1.50*Q. How can I generate them automatically?
RF-LAMINATE Library
How is it possible to display the RF‑LAMINATE library? We would like to check that it is up to date.
Question
How can I determine loads at particular geographic coordinates in the online service "Snow Load, Wind Speed, and Seismic Load Maps"?
Question
How do I determine the stiffness center of my structural system?
Question
Is it possible to perform design for a timber-concrete composite cross-section?
Question
Is it also possible to integrate the online service "Snow Load, Wind Speed, and Seismic Load Maps" into external applications?
Elastic critical moment for lateral-torsional buckling
What are the options in RFEM 5 or RSTAB 8 for determining the ideal elastic critical moment for lateral-torsional buckling for any cross-sections and systems/loads? Is it also possible to design flat steel (brackets, flat steel stringers of staircases)?
Question
Is the exponent n applied differently from the design standard when determining the damage parameter ζ (zeta)?
Question
How are the location-specific Geo-Zone Tool data queries calculated for the determination of various building loads?
Question
Which result combinations can I design with the RF‑/JOINTS Pro program, and what should I pay attention to?
Question
Why is the load value displayed in the online service "Geo-Zone Tool: Snow Load, Wind Speed, and Seismic Load Maps" different from the value in the corresponding standard in some cases?
Question
Does RF‑STEEL AISC perform torsion design per Design Guide No. 9?
Hybrid Timber Cross-Section
Is it possible to display stresses of hybrid timber cross-sections in RFEM 5 and RSTAB 8?
Question
When designing seismic equivalent loads with a Response Spectra Analysis (RSA) in RFEM, how can I apply the modal response parameters Ie/R according to Sect. 12.9.1.2 in the ASCE‑7‑16 to my results?
Question
Is the Gust-effect (G or Gf) from the ASCE 7‑16 Sect. 26.11 considered in RWIND Simulation?
Question
I need to define different types of lateral intermediate restrains for a single element in RF-/STEEL EC3. Is this possible?
Question
After running the design in RF‑STEEL AISC, I receive error message 1002 - Invalid cross-section of type "Channel" according to F2. What does this error mean?
Question
Is it possible to perform automatic live load reduction in RFEM or RSTAB per the ASCE, IBC, or NBCC?
Question
What is the formula used to calculate the ASCE 7 wind velocity profile?
Question
Can RF‑STEEL AISC optimize cross-sections for serviceability?
Question
How can I enter or read out a response spectrum via the COM interface in DYNAM Pro?
- 004727
- RFEM 5
- RSTAB 8
-
- Concrete Structures
- Steel Structures
- Timber Structures
- Tensile Membrane Structures
- Structural Analysis & Design
- Finite Element Analysis
- Wind Simulation & Wind Load Generation
- Stability Analysis
- Dynamic and Seismic Analysis
- Form-Finding and Cutting Patterns
- Cold-Formed Sections
- Eurocode 1
- Eurocode 3
- Eurocode 5