Ein Kehlbalken Dach mit gewählter Geometrie wird in Hinblick auf seine Schnittgrößen zwischen Berechnung mittels RFEM 6 und der Handrechnung verglichen. Pokud se týká návrhu 3 Poslední systém pod kontrolou.
V tomto příkladu porovnáváme vzpěrné délky a součinitel kritického zatížení, které lze vypočítat v programu RFEM 6 pomocí addonu Stabilita konstrukce, s ručním výpočtem. Konstrukční systém je tuhý rám se dvěma přídavnými kloubovými sloupy. Tento sloup je zatížen svislými osamělými zatíženími.
V tomto příkladu se smyk na rozhraní mezi betonem litým v různých okamžicích a příslušnou výztuží stanoví podle DIN EN 1992-1-1. Výsledky získané v programu RFEM 6 budou porovnány s následujícím ručním výpočtem.
Sadnutí tuhého čtvercového základu na jezerním jílu [1] se spočítá v programu RFEM. Vymodelována je čtvrtina základu. Šířka základů je 75,0 m na obou stranách. Pro generování výsledků se používají fáze výstavby.
Stanoví se přípustná pevnost v osovém tlaku kloubového nosníku o délce 2,8 m různých průřezů ze slitiny 6061-T6 a bočně vetknutého proti vybočení okolo nejslabší osy podle Aluminum Design Manual 2020.
A symmetrical shallow structure is made of eight equal truss members, which are embedded into hinge supports. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point when the snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. Vlastní tíha se v tomto příkladu nezohledňuje. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at the given deflections.
Konstrukce se skládá ze čtyř prutů, které jsou uloženy na kloubových podporách. The structure is loaded by a concentrated force and alternatively by imposed nodal deformation over the critical limit point, when snap-through occurs. Imposed nodal deformation is used in RFEM 5 and RSTAB 8 to obtain the full equilibrium path of the snap-through. The self-weight is neglected in this example. Determine the relationship between the actual loading force and the deflection, considering large deformation analysis. Evaluate the load factor at given deflections.
A cantilever beam with an I-beam cross-section of length L is defined. The beam has five mass points with masses m acting in the X-direction. Vlastní tíhu zanedbáme. The frequencies, mode shapes, and equivalent loads of this 5-DOF system are analytically calculated and compared with the results from RSTAB and RFEM.
Analyticky stanovíme torzní konstantu pro průřez trubky (kruhovou oblast) a výsledky porovnáme s numerickým řešením v programech RFEM 5 a RSTAB 8 pro různé tloušťky stěn.