1.3 Opening the RF-CONCRETE Surfaces Add-on Module

RFEM provides the following options to start the RF-CONCRETE Surfaces add-on module.

You can start the add-on module with the RFEM menu item

Add-on Modules → Design - Concrete → RF-CONCRETE Surfaces.

Alternatively, you can start the add-on module in the Data navigator by selecting

Add-on Modules → RF-CONCRETE Surfaces.

If results from RF-CONCRETE Surfaces are already available in the RFEM model, you can also start the design module in the panel:

Set the relevant design case of RF-CONCRETE Surfaces in the load case list of the menu bar. Then use the [Show Results] button to display the reinforcements graphically.

Now you can click the [RF-CONCRETE Surfaces] button in the panel to open the add-on module.