Check out these tips to help you get started with the RFEM program.
Definition of Not Covered Member Reinforcement
Video
First Steps with RFEM
Description
This video shows the work with the diagrams for the required, provided, and not covered reinforcement. The uncovered value of the required member reinforcement is defined to fulfil the design checks.
Keywords
RFEM6 member Diagram concrete design FEM software FEA software Finite element software Construction Civil engineering Structural engineer Structural design Structural designer Structural analysis RFEM 6 RSTAB 9 Dlubal Software
Write Comment...
Write Comment...
Contact Us
Do you have any questions about our products or which are best suited for your design projects? Contact us via phone, email, or chat or find suggested solutions and useful tips on our FAQ page available 24/7.
New
Reinforced Concrete Column Design per ACI 318-19 in RFEM 6
Using the Concrete Design add-on, concrete column design is possible according to the ACI 318-19.
New
Concrete Design | Reinforced Concrete Design with Net Concrete Area
During the cross-section design, you can control whether the concrete surface is applied behind the reinforcing bars or is subtracted from the concrete cross-section. The design of the net concrete cross-section is mainly used for highly reinforced cross-sections.-
The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?
- I would like to export nodal support forces of several load cases, load combinations and result combinations into an Excel spreadsheet in RFEM 6. How should I proceed?
- Where can find the option to hide the defined types (for example, design supports or effective lengths)?
- How do I create a user-defined Design Situation with my own chosen load combinations?
- I would like to perform punching design of a floor slab. I have selected nodes for the design, but they are marked as invalid. Where did I make a mistake?
- How do I perform stability analysis to determine the critical load factor in RFEM 6?
-
How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
Social Networks
Frequently Visited Pages
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?
