Answer:
If you have a trapezoidal load value close to zero, for example, the scale might be incorrect, as there are very small values to be displayed. In this case, there is a setting error in the display properties.
Just proceed as follows:
- Right-click the load to open the shortcut menu.
- Select "Display Properties…"
- Click on the magnifying glass at the size scale 1 [kN/m].
- Enter the minimum value of the minimum limits at 0.1%, for example.
- Click OK to confirm.
- The zero value is not displayed on the loads (see Image 03).
- If the zero value is displayed, it certainly contains decimal digits. By zooming, you discover that the diagram does not form a closed angle at the end (see Image 04).
The scale of your graphic will be adjusted and correct immediately.
Important Note:
