ADM 2020 Aluminum Design in RFEM 6 (USA)
Information about the Free Webinar
Webinars provide the opportunity to gain expert knowledge and to ensure you’re getting the most out of your Dlubal programs.
Date | Time
Free Webinar | ADM 2020 Aluminum Design in RFEM 6 (USA)
|04:45||RSECTION calculation acc. to finite element analysis method|
|11:04||RSECTION calculation acc. to thin-walled analysis method|
|17:40||RFEM aluminum structure member modeling overview|
|27:32||Member input for Aluminum Design add-on|
|43:40||Structure loading overview including RWIND wind loads|
|49:17||Design situations and load combinations overview|
|53:38||Review of analysis and design results|
Presentation Model to Download
Amy Heilig, PE
CEO - USA Office
Sales & Technical Support Engineer
Amy Heilig is the CEO of the USA office located in Philadelphia, PA. In addition, she provides sales and technical support and continues to aid in the development of Dlubal Software programs for the North American market.
Do you have questions about our webinars? Need advice on which webinars are best for your upcoming design project? Contact us via phone, email, chat, or forum or find suggested solutions and useful tips on our FAQ page available 24/7.
This article shows you how to define different types of member transverse stiffeners in RFEM 6 and RSTAB 9. It also shows you how to consider them in the design as well as the calculation of members with 7 degrees of freedom.
When connecting tension-loaded components with bolted connections, it is absolutely necessary to consider the cross-section reduction due to the bolt holes in the ultimate limit state design. The Aluminum Design add-on facilitates this procedure by entering a member local section reduction.
My beam has a continuous lateral support and therefore lateral torsional buckling (LTB) is not a concern. How do I define the effective length?
- How do I consider the strength of weld-affected zone for aluminum?
- How can I carry out case-related design for different load situations?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
- How do I create a user-defined Design Situation with my own chosen load combinations?
- Where can I find the materials for the corresponding National Annexes in RFEM 6 and RSTAB 9?
- How do I apply load on members that are non coplanar in RFEM 6?
- How do I apply wind load on members of open structures?
- I encountered a sharing violation while importing a dxf file into SHAPE‑THIN. What is the issue?