Answer:
Dlubal parameters are parameters in Revit that do not exist by default. They are only enabled after activation ("Add Parameters" → "Start") in various dialog boxes.In this case, the information is specific to RFEM/RSTAB and can be stored in Revit. When exporting from Revit to Dlubal Software, you can export and convert this information from RFEM/RSTAB.
"Without Tension"
- to be found in the analytical wall properties
- corresponds to the "Without membrane tension" surface type stiffness
- corresponds to the "Without membrane tension" surface type stiffness
"Surface Support"
- to be found in the analytical slab or plate properties
- creates a surface support with the specified spring constants in RFEM
"Dlubal Name (Material)"
- can be found in the user-defined material parameters
- possible to directly assign the Dlubal material name (without using the conversion table)
"Dlubal Name (Cross-Section)"
- to be found in the model properties of columns or beams
- possible to directly assign the Dlubal cross-section name (without using the conversion table)
"Member Type Truss/Tension Member"
- to be found in the analytical beam or support properties
- corresponds to the Truss or Tension member type in RFEM/RSTAB
.jpg?mw=760&hash=8446d7a9a94a0c83976d63116549104bbe04f460)
.jpg?mw=760&hash=0054d4d7b87194a52bffbb6a0d931197c71e903d)
.jpg?mw=350&hash=9689cb7a943dc7836a932b35bfde4a01caf8bb13)
.jpg?mw=350&hash=0699344bce74030cffe080ac61d2fafe33a8c178)
.png?mw=600&hash=49b6a289915d28aa461360f7308b092631b1446e)
