29 Results
View Results:
Sort by:
Design of Hydraulic Steel Structures
Can I analyze and design hydraulic steel structures with the Dlubal programs?
Bolt Holes in Thin-Walled Cross-Sections
How can I model bolt holes in thin-walled cross-sections?
Why does the eHORA map of Austria give different snow loads than your Geo-Zone tool?
Why does the eHORA map of Austria give different snow loads than your Geo-Zone tool?
Welds in RFEM 6
In the case of stairs with a complicated geometry, it is often difficult to design welds by using the analytical methods. How can I do this with RFEM?
Combinations for Road Bridges According to EN 1991-2 in RFEM 6
Does RFEM 6 include the combinations for road bridges according to EN 1991‑2?
Question
Is it possible to design the support pressure or the compression perpendicular to the grain in RX‑TIMBER?
Question
How can I display the deformation in the current construction stage and in relation to the initial system in RF‑STAGES?
Question
Which types of glued-laminated beams can be calculated with a raised dry joint?
Question
I have calculated a box girder. Which surface results or surface stresses can I use to evaluate the buckling behavior of the web plates?
Question
Is it also possible to specify a cable length in RF‑FORM‑FINDING?
Question
How can I control an overpressed joint in the ridge?
- 004165
- RFEM 5
- RSTAB 8
-
- Power Plants
- Steel Structures
- Process Manufacturing Plants
- Bridges
- Towers and Masts
- Temporary Structures
- Scaffolding and Rack Structures
- Offshore Structures
- Silos and Storage Tanks
- Buildings
- Piping Systems
- Cranes and Craneways
- Renewable Energy Structures
- Conveyor Structures
- Drilling Structures
- Stairway Structures
- Wind Simulation & Wind Load Generation
Question
How is it possible to consider the real cross-section geometry of member elements in RWIND Simulation?
Question
Is it possible to define orthotropic surface loads in RFEM? I would like to subject a surface to different temperature loads per direction.
Question
The calculation of my model results in unrealistically high stresses at many locations. What could be the reason for this?
Question
Is it also possible to enter the temperature for a surface in the XZ plane by using the height (variable in Z)?
Question
Does Dlubal Software provide any solutions for composite bridge construction, or perhaps also verification examples or reference objects?
Question
In the case of the "Initial strain from other LC/CO" feature, I cannot retrace internal forces. How is this function mapped internally?
Question
Why are the results in the RF‑/STAGES add-on module not consistent with the corresponding load cases and combinations in the RFEM or RSTAB program?
Question
I have created a 2D frame and would like to assign a lateral and torsional restraint to the ridge. Do I have to enter an intermediate lateral restraint or a nodal support in RF‑/STEEL EC3?
Question
Which analysis is used in RF‑STAGES or STAGES to calculate temporary loads and the generated combinations?
- 002913
- RF-DYNAM Pro | Natural Vibrations 5
- RF-DYNAM Pro | Equivalent Loads 5
-
- RF-DYNAM Pro | Forced Vibrations 5
- RF-DYNAM Pro | Nonlinear Time History 5
- DYNAM Pro | Natural Vibrations 8
- DYNAM Pro | Equivalent Loads 8
- DYNAM Pro | Nonlinear Time History 8
- Concrete Structures
- Steel Structures
- Timber Structures
- Mechanical Engineering
- Process Manufacturing Plants
- Bridges
- Dynamic and Seismic Analysis
- Nonlinear Dynamics