In addition to our technical support (e.g. via chat), you’ll find resources on our website that may help you with your design using Dlubal Software.
Frequently Asked Questions (FAQ)
Customer Support 24/7
Using the RF-/DYNAM Pro add-on module, it is possible to exchange the following results via the RF-COM/RS-COM Interface:
- Nodal deformations (table 5.20)
- Member deformations
- Surface deformations (RFEM)
- Nodal masses
- Effective modal mass factor
Furthermore, the internal forces, deformations, and support reactions of the equivalent load cases can be output via the RFEM/RSTAB interface. Help files are available for each of these output options. These files are described in this article.
In this case, you have the option to print the image in the time course diagram directly into the printout report. Proceed as described in the picture.
The symbols in the DYNAM graphic indicate twisting members.
If there wasn't such an indication, it wouldn't be possible to recognize any torsion, as the members are related to the centroidal axis in the graphic. This is the reason why a short vertical line with small end circles was chosen for the graphical representation.
In the animation mode, you will see that these symbols rotate, thus representing torsions.
Did you find your question?
If not, contact us via our free e-mail, chat, or forum support, or send us your question via the online form.
Your support is by far the best
“Thank you very much for the useful information.
I would like to pay a compliment to your support team. I am always impressed how quickly and professionally the questions are answered. In the industry of structural analysis, I use several software including service contract, but your support is by far the best.”