24 Results
View Results:
Sort by:
Question
How do I determine the stiffness center of my structural system?
Question
Why do the results of members and sets of members differ in the design?
Question
For the settlement calculation in the RF‑SOILIN add-on module, the specific weight gamma and gamma,sat are required for the soil. What do I need the value gamma,sat for, and how is it assumed in the calculation?
Question
When performing the fire resistance design with TIMBER Pro, I get Error 10001. How can I fix the error?
Question
Is it possible to design the support pressure or the compression perpendicular to the grain in RX‑TIMBER?
Question
Is it possible to import effective lengths from RF‑STABILITY or RSBUCK in RF‑/TIMBER Pro?
Imperfection from Mode Shape
How do I create an imperfection based on a mode shape in RFEM 6?
Question
What happens if I activate the "Soil failure" function in RF‑SOILIN?
Question
I have a question about the results of the serviceability limit state design: How is the increment of the dead load by the factor of 1.8 and the imposed load by 1.48 explained in the result combinations for the SLS design?
Question
I cannot calculate members with double rectangular cross-sections and linearly variable cross-section height in TIMBER Pro. What is the reason?
Question
How can I create a drilled beam in RFEM?
Question
How can I generate a restraint or a spring for the support in RX‑TIMBER Glued-Laminated Beam?
Question
I have used the RF‑/DYNAM Pro add-on module to generate the governing result combinations of seismic loads. What is the next procedure to perform the design of the individual structural components?
Question
Which result combinations can I design with the RF‑/JOINTS Pro program, and what should I pay attention to?
- 004727
- RFEM 5
- RSTAB 8
-
- Concrete Structures
- Steel Structures
- Timber Structures
- Tensile Membrane Structures
- Structural Analysis & Design
- Finite Element Analysis
- Wind Simulation & Wind Load Generation
- Stability Analysis
- Dynamic and Seismic Analysis
- Form-Finding and Cutting Patterns
- Cold-Formed Sections
- Eurocode 1
- Eurocode 3
- Eurocode 5