Office Building with Underground Parking
Customer Project
Structural Engineering |
gip Gesellschaft für innovative Planung mbH Dertmanns Feld 39 44797 Bochum, Germany Phone 02335-97 53 999 Fax 02335-97 53 998 [email protected] |
Write Comment...
Write Comment...
Contact Us
Do you have further questions or need advice? Contact us via phone, email, chat, or forum, or find suggested solutions and useful tips on our FAQ page, available 24/7.

New
Consideration of Shear Stiffness for a Cross-Section Calculation in RFEM 6
This article shows you the internal forces and displacements of a continuous beam calculated both with and without consideration of shear stiffness.
- How do I create a user-defined Design Situation with my own chosen load combinations?
- How are the internal forces for a downstand beam (rib) determined in RFEM?
-
Although all the designs for a member have been complied with, I get an "Uncovered reinforcement". How is this possible?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?
-
How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
- Where can I find the graphical results of punching shear in the concrete design? Especially the distribution of shear forces at the critical perimeter or the punching loads.
- Is it possible to display the reinforcement description in RFEM 6?
- Where can I find the graphical results of punching shear in the concrete design? Especially the distribution of shear forces at the critical perimeter or the punching loads.
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?