The structural analysis software RFEM 6 is the basis of a modular software system. The main program RFEM 6 is used to define structures, materials, and loads of planar and spatial structural systems consisting of plates, walls, shells, and members. The program also allows you to create combined structures as well as to model solid and contact elements.
RSTAB 9 is a powerful analysis and design software for 3D beam, frame, or truss structure calculations, reflecting the current state of the art and helping structural engineers meet requirements in modern civil engineering.
Do you often spend too long calculating cross-sections? Dlubal Software and the RSECTION stand-alone program facilitate your work by determining section properties of various cross-sections and performing a subsequent stress analysis.
Do you always know where the wind is blowing from? From the direction of innovation, of course! With RWIND 2, you have a program at your side that uses a digital wind tunnel for the numerical simulation of wind flows. The program simulates these flows around any building geometry and determines the wind loads on the surfaces.
Are you looking for an overview of snow load zones, wind zones, and seismic zones? Then you are in the right place. Use the Geo-Zone Tool to determine quickly and efficiently snow loads, wind speeds, and seismic data according to ASCE 7‑16 and other international standards.
Would you like to try out the capabilities of the Dlubal Software programs? You have the opportunity to do so! The free 90-day full version allows you to thoroughly test all our programs.
In this webinar, you will learn how to design a tent hall consisting of aluminum cross-sections in RFEM 6.
Free Webinar | CSA A23.3:19 Concrete Building Design in RFEM 6 (USA)
This webinar will provide an introduction to concrete building design acc. to the CSA A23.3:19 in RFEM 6.
Free Webinar | AISI S100 / CSA S136 Cold-Formed Steel Design in RFEM 6 (USA)
This webinar will provide an introduction to cold-formed steel member design acc. to the AISI S100 / CSA S136 in RFEM 6.
This webinar provides an introduction to aluminum modeling and design in RFEM 6 and RSTAB 9.
This webinar provides an introduction to the design of aluminum structures in RFEM 6 and RSTAB 9.
Webinars provide the opportunity to gain expert knowledge and to ensure you’re getting the most out of your Dlubal programs.
In this webinar, we will show you how to model and design aluminum structures in the structural analysis programs RFEM 6 and RSTAB 9.
This webinar shows you how to model and design an aluminum structure in RFEM 6 and RSTAB 9.
Dlubal webinars provide you with the opportunity to gain expert knowledge and to ensure you are getting the most out of your Dlubal Software programs.
The online training shows you how to use the Dlubal software RFEM for the form-finsing and cuttring pattern design of tensile membrane structures, and the wind tunnel numerical analysis software RWIND Simulation to calculate the wind loads.
This webinar demonstrates the general concrete design workflow according to the CSA A23.3:19 in RFEM and the RF-CONCRETE add-on modules.
Content
Content:
Duration: 36:28 min.