56 Results
View Results:
Sort by:
SLS Rotational Deformations of Crane Runway Girder
Is it possible in the CRANEWAY software to obtain the SLS rotational deformations of a continuous beam at the supports for an isostatic beam in the web plane?
Welds in RFEM 6
In the case of stairs with a complicated geometry, it is often difficult to design welds by using the analytical methods. How can I do this with RFEM?
Fatigue Design
Where is the fatigue design activated in the CRANEWAY program?
Crane Library
In CRANEWAY, there is a crane library with templates. Why is it grayed out?
Question
How can I optimize the calculation time in CRANEWAY?
Question
Where can I find the determined support forces for the crane runway girder? At the bottom flange of the crane runway girder or in the shear center of the cross-section?
Question
Is it possible to manually adjust detail categories or a stress cycle of the detail categories?
Question
How can I obtain internal forces, calculated in CRANEWAY, for a special x-location?
Entering Sway Bracing in RFEM or RSTAB
How can I consider a sway bracing in CRANEWAY?
Deformations of Craneway
I am trying to manually check the deformations from the CRANEWAY add-on module. However, I obtain large deviations. How to explain the differences?
Question
How can I model and design a crane runway girder with Dlubal Software?
Question
How can I create a drilled beam in RFEM?
Question
Is it possible to design intermittent welds in the CRANEWAY add-on module?
Question
Is the load on beams correct when transferring the data of the crane data sheet to CRANEWAY with the correct sign?
Question
Where can I find the action category for cranes in my load cases?
Question
How can I display shear stresses on null elements in SHAPE‑THIN?
Question
Is it necessary to enter the loads of a crane for each axle or wheel in the table of crane loads in Window 1.4?
Question
Is it possible to design a crane runway girder without stiffeners on supports in CRANEWAY?
Question
I have calculated a box girder. Which surface results or surface stresses can I use to evaluate the buckling behavior of the web plates?
Question
How can I model several simply supported beams in a row in CRANEWAY?
Question
What is the difference between the dongle drivers of CRANEWAY and RFEM or RSTAB?
Question
I would like to use the CRANEWAY add-on module to design a suspension crane. Where are design points 0, 1, and 2 for the stress analysis on the bottom flange and for the fatigue design?
Question
How can I introduce releases on the supports in the CRANEWAY program to prevent the effect of continuity?
Question
Where can I change the steel grade of a crane girder? Although I have set Steel St 37.2 in RSTAB, only S235 is used for the calculation in CRANEWAY.
- 004165
- RFEM 5
- RSTAB 8
-
- Power Plants
- Steel Structures
- Process Manufacturing Plants
- Bridges
- Towers and Masts
- Temporary Structures
- Scaffolding and Rack Structures
- Offshore Structures
- Silos and Storage Tanks
- Buildings
- Piping Systems
- Cranes and Craneways
- Renewable Energy Structures
- Conveyor Structures
- Drilling Structures
- Stairway Structures
- Wind Simulation & Wind Load Generation