Prefabricated Garage Constructed in Reinforced Concrete
Customer Project
The garage was analyzed during a 30-minute presentation on CeBIT 2002 on the customer's request.
Structural Engineering |
Dlubal Software GmbH Am Zellweg 2 93464 Tiefenbach, Germany Tel.: 094673-92030 |
The garage is supported by four circular surfaces in a floor slab. The supports have been designed as a surface elastic foundation.
Write Comment...
Write Comment...
Contact Us
Do you have further questions or need advice? Contact us via phone, email, chat, or forum, or find suggested solutions and useful tips on our FAQ page, available 24/7.

New
Consideration of Shear Stiffness for a Cross-Section Calculation in RFEM 6
This article shows you the internal forces and displacements of a continuous beam calculated both with and without consideration of shear stiffness.
-
Although all the designs for a member have been complied with, I get an "Uncovered reinforcement". How is this possible?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?
- In RFEM 6, is it possible to display a graphic with the distribution of the required reinforcement in the DIN A0 format?
- How do I define a member as a cantilever and not as supported at both ends for serviceability or deflection design?
- The limit stress is activated, but my stress ratio is “non-designable” in the Stress-Strain Analysis add-on. What could be the reason?