45 Results
View Results:
Sort by:
Question
How is coupling between individual layers controlled in the RF‑LAMINATE add-on module?
Question
How do I superimpose generated equivalent loads from the seismic analysis?
Question
Why does the web service show "ERROR: Map not found."?
Question
How can I display the stiffness matrix of the surfaces from the RF‑LAMINATE add-on module in the printout report?
Question
Why is the "without glue at narrow sides" check box not selected by default in the RF‑LAMINATE add-on module?
Question
Are the models and presentations from Info Day 2019 freely available, and can you send them to me?
Question
Red values are displayed in the intermediate results of RF‑SOILIN. Why?
Question
How do I determine the stiffness center of my structural system?
Question
Where in the RF‑LAMINATE add-on module can I find which stress value is used for the design?
Question
What is the meaning of the "Activate Weld Design" option in the detailed settings of RF‑/STEEL EC3?
Question
Can I rotate a foundation about the Z-axis in the RF‑FOUNDATION Pro add-on module?
Design of Solids
Is it possible to use the add-on modules for RFEM 5 to design concrete solids?
Question
When designing seismic equivalent loads with a Response Spectra Analysis (RSA) in RFEM, how can I apply the modal response parameters Ie/R according to Sect. 12.9.1.2 in the ASCE‑7‑16 to my results?
Question
Is the Gust-effect (G or Gf) from the ASCE 7‑16 Sect. 26.11 considered in RWIND Simulation?
Question
Is it possible to perform automatic live load reduction in RFEM or RSTAB per the ASCE, IBC, or NBCC?
Question
Is the compression reinforcement calculated for the ultimate limit state design in RF‑CONCRETE Surfaces? Or is it only possible in RF‑CONCRETE Members?
Question
Do I have to add the reinforcement for ribs from RF‑CONCRETE Members and RF‑CONCRETE Surfaces?
Question
What does the "Calculate grid points result values for graphics" option set?
Question
I am trying to verify RF‑CONCRETE Surfaces based on the results of the example in the manual. Chapter 2.4.3 describes the determination of the statically required reinforcement. Unfortunately, I cannot create an example that exactly represents these results. Can you send me the corresponding example?
Question
How can I enter or read out a response spectrum via the COM interface in DYNAM Pro?
Question
For design with CONCRETE NL, is the creep applied to the entire cross-section, or only to the concrete compression zone?
Question
When I create a user-defined result value, the RFEM solver window opens briefly and the calculation is apparently performed again. Why? I have already performed the calculation.
Question
Is it also possible to reduce the shear force on a support or perform design with the shear force at a distance d to the support in RF‑CONCRETE Surfaces?
- 004727
- RFEM 5
- RSTAB 8
-
- Concrete Structures
- Steel Structures
- Timber Structures
- Tensile Membrane Structures
- Structural Analysis & Design
- Finite Element Analysis
- Wind Simulation & Wind Load Generation
- Stability Analysis
- Dynamic and Seismic Analysis
- Form-Finding and Cutting Patterns
- Cold-Formed Sections
- Eurocode 1
- Eurocode 3
- Eurocode 5