62 Results
View Results:
Sort by:
Different Design Configurations by Case
How can I perform member design by case for different settings in the design configuration?
Single-Angle Compression Member According to AISC Section E5
How can I design single-angle compression member according to AISC Section E5?
Required Reinforcement and Reinforcement Layout
Why do I only obtain the total reinforcement in the Results navigator under "Required Reinforcement", and no result for the top and bottom reinforcements separately?
Cutting and Editing Plates
Why is it not possible to select the plate that I want to adjust in the “Plate Cut” and “Plate Editor” components?
Dimensions in Steel Joint
Can I add dimensions in the Steel Joints add-on?
Stiffeners at Girder Flanges of Rigid Frame Joint
How do the stiffeners on the outer flange edges of a rigid frame joint beam affect the maximum resistant moment as well as the rotational stiffness and the accompanying displacements of a frame structure?
Different Stresses in Static Analysis and Stress-Strain Analysis
Why are the stresses of the structural analysis different from those calculated with the Stress-Strain Analysis add-on?
Component-Based Finite Element Method (CBFEM) in RFEM 6
What is the component-based finite element method (CBFEM)?
Reinforced Concrete Design of Solids
Is it possible to use the add-ons for RFEM 6 to design concrete solids?
Programs for Concrete Structures
Which programs and add-ons are suitable for concrete structures?
Aluminum and Lightweight Structures
I would like to design an aluminum structure. Is it possible to use RFEM or RSTAB for this?
Stability Analysis of Structural Components with Asymmetric Cross-Section
Is it possible to use the General Method according to EN 1993‑1‑1, 6.3.4 to design structural components with an asymmetric cross-section in the Steel Design add-on for RFEM 6 or RSTAB 9?
Add-ons for Concrete Structures
Which products do you recommend for the structural analysis and design of reinforced concrete structures?
Scaffolding and Rack Structures
We are looking for a program for scaffolding and rack structures. Is Dlubal Software suitable for this?
Design Cases
Can I use design cases in RFEM 6 in the same way as in RFEM 5?
Tensile Membrane Structures
Which Dlubal programs do I need for tensile membrane structures?
- 005450
- RFEM 6
- RSTAB 9
-
- Steel Design for RFEM 6
- Steel Design for RSTAB 9
- Aluminum Design for RFEM 6
- Aluminum Design for RSTAB 9
- Form-Finding for RFEM 6
- Steel Structures
- Aluminum and Lightweight Structures
- Temporary Structures
- Tensile Membrane Structures
- Structural Analysis & Design
- Form-Finding and Cutting Patterns
- Dynamic and Seismic Analysis
- Eurocode 3
- Eurocode 9
- ANSI/AISC 360
- ADM
Temporary Structures
I would like to analyze temporary structures. Which programs do you recommend?
- 005437
- RFEM 6
- RSTAB 9
-
- Steel Design for RFEM 6
- Steel Design for RSTAB 9
- Steel Joints for RFEM 6
- Torsional Warping (7 DOF) for RFEM 6
- Torsional Warping (7 DOF) for RSTAB 9
- Steel Structures
- Structural Analysis & Design
- Stress Analysis
- Stability Analysis
- Warping Torsion Analysis
- Steel Connections
- Cold-Formed Sections
- Eurocode 3
- ANSI/AISC 360
- CSA S16
- IS 800
- GB 50017
- SP 63.13330
- BS 5950-1
- AS 4100
- SIA 263