Back to Online Manuals

121x

004227

0001-01-01

Select Manual

Overview

1 Introduction

2 Installation

3 User Interface

4 Model Data

5 Load Cases and Combinations

6 Loads

7 Calculation

8 Results

9 Results Evaluation

10 Printout

11 Program Functions

12 File Management

13 Literature

4.27 Surface Release Types

General description

With a surface release, it is possible to decouple the model at a surface -- for example, if surfaces are linked flexibly or transfer only compression forces. So it is possible to define nonlinear contact properties for surfaces, for example, without generating a contact solid between surfaces.

Note

You have to define a release with specific properties in a Surface Release Type first. You can then assign them to members, surfaces, and solids that share a surface (see Chapter 4.28).

Image 4.214 *New Surface Release Type* dialog box

Image 4.215 Table 1.27 *Surface Release Types*

Release or Spring u_x / u_y / u_z

You can define a release within the surface plane (u_x, u_y) or perpendicular to the surface (u_z) by selecting the corresponding displacement in the dialog box or table. With the properties of a Spring, you can also model flexible releases.

The directions of the displacements x, y, and z refer to the axis system of the surface. You can display the surface axes by using the surface shortcut menu or the Display navigator (see Figure 4.75).

You can also assign nonlinear properties to the releases. Select the Nonlinearity from the list and define it with the button in the dialog box. The input of nonlinear release properties is described in Chapter 4.14.

Parent Chapter

4 Model Data