Governing results

In the result tables of the Governing Results category, the internal forces of members and surfaces as well as the stresses are listed that lead to the maximum utilizations of the designed objects.

Table | Governing Internal Forces by Member

The results are sorted in the tabs according to the following criteria:

• Objects (members, member ends, member sets, member set ends, representatives, surfaces, surface sets)
• Loads (design situations, load combinations)

The tables list the internal forces for each object that are governing for each design type and thus lead to the highest utilization. The respective location is also specified.

To display only the internal forces of the governing design of an object, set the Max option in the result filter list.

Table | Governing Internal Forces by Member for Governing Design

With the internal forces of the governing designs at the member or member set ends, it is possible, for example, to estimate which load combination is considered for the connection design in each case.

The chapter Utilizations on Members describes how you can filter the results by limit state and by utilization.