The result tables in the Governing Results category list the internal forces in members and surfaces, as well as the stresses that lead to the maximum design ratios for the designed objects.
The results are sorted in the tabs according to the following criteria:
- Objects (members, member ends, member sets, member set ends, representatives, surfaces, surface sets)
- Loads (design situations, load combinations)
The tables list the internal forces by object, which are governing for each type of design check and thus result in the highest design ratio. The respective location is also specified.
In order to only display the internal forces of the governing design check of an object, select the ‘’'Max'‘’ option in the result filter list.
For example, the internal forces from the governing design checks at the ends of members or member sets can be used to estimate which load combinations should be considered for the joint design.
The chapter Design Ratios on Members describes how to filter the results by limit state and by design ratio.