Eine geschichtete quadratische orthotrope Platte ist in ihrem Mittelpunkt vollständig befestigt und einem Druck ausgesetzt. Compare the deflections of the plate corners to check the correctness of the transformation.
Bestimmen Sie die maximale Durchbiegung von vier unten befestigten Stützen, die oben durch einen starren Block verbunden sind. The block is loaded by pressure and modeled by an elastic material with a high modulus of elasticity. The outer columns are modeled as orthotropic elastic material, and the inner columns as orthotropic elastic-plastic material with the same elastic parameters as the outer columns and plasticity properties defined according to the Tsai-Wu plasticity theory.
A timber beam reinforced by two steel plates at the ends is loaded by pressure. The wood fibers are parallel to the upper loaded side of the beam. Die plastische Oberfläche wird nach der Tsai-Wu-Plastizitätstheorie beschrieben.
An beiden Enden ist ein dreidimensionaler Block aus elastisch-plastischem Material mit Verfestigung befestigt. The block's middle plane is subjected to a pressure load. The surface plasticity is described according to the Tsai‑Wu plasticity theory.
Eine breite Platte mit Öffnung wird mittels Zugspannung in einer Richtung belastet. The plate width is large with respect to the hole radius, and it is very thin, considering the state of the plane stress.
A timber beam reinforced by two steel plates at the ends is loaded by pressure. The wood fibers are parallel to the upper loaded side of the beam. Die plastische Oberfläche wird nach der Tsai-Wu-Plastizitätstheorie beschrieben.
Vier Stützen sind unten fixiert und oben durch einen starren Block verbunden. The block is loaded by pressure and modeled by an elastic material with a high modulus of elasticity. The outer columns are modeled by linear elastic material and the inner columns by a stress-strain diagram with decaying dependence. Assuming only the small deformation theory and neglecting the structure's self-weight, determine its maximum deflection.
Bestimmen Sie die maximale Durchbiegung des Kragarms aus zwei Glasscheiben und einer dazwischenliegenden Folienschicht. The plate is fully fixed at one end and subjected to uniform pressure.
Ein I-Profil-Kragträger ist am linken Ende gelagert und durch Moment belastet. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).
Eine Verbundplatte, die aus drei Glasschichten einer Folienschicht und einem Innenraum mit trockener Luft besteht, ist vollständig befestigt und mit einer variablen Temperatur belastet. Neglecting its self-weight, determine the plate's maximum deflection.