Search Result
17 result(s) for "result beam"
Additional Surface Result Points
/en/downloads-and-information/documents/online-manuals/rfem-6/004116
Beam Panel
/en/downloads-and-information/documents/online-manuals/rfem-6/005090
Filtering Result Tables
/en/downloads-and-information/documents/online-manuals/rfem-6/004065
Member Result Intermediate Points
/en/downloads-and-information/documents/online-manuals/rfem-6/000058
Result Combinations
/en/downloads-and-information/documents/online-manuals/rfem-6/000261
Result Diagrams
/en/downloads-and-information/documents/online-manuals/rfem-6/000484
Result Evaluation
/en/downloads-and-information/documents/online-manuals/rfem-6/002205
Result Sections
/en/downloads-and-information/documents/online-manuals/rfem-6/000084
Result Smoothing
/en/downloads-and-information/documents/online-manuals/rfem-6/001104
Result Values on Surfaces
/en/downloads-and-information/documents/online-manuals/rfem-6/001107
Results
/en/downloads-and-information/documents/online-manuals/rfem-6/000364
Results by Line
/en/downloads-and-information/documents/online-manuals/rfem-6/000480
Results by Member
/en/downloads-and-information/documents/online-manuals/rfem-6/000481
Results by Node
/en/downloads-and-information/documents/online-manuals/rfem-6/000479
Results by Solid
/en/downloads-and-information/documents/online-manuals/rfem-6/000483
Results by Surface
/en/downloads-and-information/documents/online-manuals/rfem-6/000482
Surface Results Adjustments
/en/downloads-and-information/documents/online-manuals/rfem-6/000080
Most searched
Most visited
In this article, you will learn how to model and design cable structures in RFEM 6 or RSTAB 9.
This article describes and explains the influence of bending stiffness of cables on their internal forces. Furthermore, the text provides information on how this influence can be reduced.
The ASCE 7-22 Standard [1], Sect. 12.9.1.6 specifies when P-delta effects should be considered when running a modal response spectrum analysis for seismic design. In the NBC 2020 [2], Sent. 4.1.8.3.8.c gives only a short requirement that sway effects due to the interaction of gravity loads with the deformed structure should be considered. Therefore, there may be situations where second-order effects, also known as P-delta, must be considered when carrying out a seismic analysis.
The data exchange between RFEM 6 and Allplan can be done using various file formats. This article describes the data exchange of a determined surface reinforcement using the ASF interface. This allows you to display the RFEM reinforcement values as level curves or colored reinforcement images in Allplan.
Get a better understanding of the stress distribution within member cross-sections using clipping planes.
In RFEM, the oriented strand board (OSB) material is available for the USA and Canada. The material parameters are taken from the "Panel Design Specification manual".
The "Bracing in Cells" function allows you to generate diagonal bracing with just a few clicks. You can find this feature under Tools → Generate Model – Members → Bracing in Cells.
In RFEM and RSTAB, you can visualize the flow field quantities of pressure, velocity, turbulence kinetic energy, and turbulence dissipation rate for the wind simulation.
The clipping planes are aligned with the respective wind direction.