A result section creates a cutting plane or intersecting line through the model. This allows you to evaluate the results at the intersecting lines with surfaces and solids.
Categories
Define the 'Type' of the result section. The list provides two definition types to choose from:
- 2 Points and Vector: You define a cutting plane freely through the model.
- Line: You apply a section along one or more existing lines.
The sections of the dialog box change depending on the setting.
By default, the result section refers to the global XYZ 'Coordinate system'. However, you can also use a user-defined system.
Use the 'Show Section in Direction' list to define in which surface plane the section diagram is to be displayed.
With the default setting 'Locally in +z', the results are plotted perpendicular to the surfaces captured by the cutting plane.
1st/2nd Point or Line
Depending on the section type, you can define the two boundary points of the section or the line in these sections.
Enter the 'Point Coordinates' of the first and second point. Using the button
, you can also determine the boundary points graphically. Adjust the work plane if necessary if you want to define arbitrary points in the work window rather than nodes.
A straight line is created from each of the two points in the direction of the 'Projection' (see section below), thus defining the cutting plane. If this plane intersects a surface, the result diagram is displayed along this intersecting line. If several surfaces are intersected by the plane, the result diagrams are displayed in each of these surfaces. In the 'Assigned to' section, you can control which surfaces are captured by the result section.
Options
Activate the 'Show Values on Isolines' check box if you want to read the result values at the intersections of the isolines in the isoline display.
Projection in Direction
The plane of a result section is defined by two points and a projection vector. In the list, you can select a vector in addition to the three global projection directions in order to define the third point of the plane in a user-defined way.
Display of Result Sections
The display of result sections is controlled in the 'Navigator - Results'. There you can define which results and which sections are displayed. The following image shows two result sections: In section 1, a vertical cutting plane is applied through the wall and ceiling surfaces; section 2 captures the results along two boundary lines.